Accessories

Tendoning Jig doesn't Fit Table Saw!
The tendoning jig doesn't fit my Craftsman table saw!! I have written the seller, Temberline, numerious times. I was finally told to grind the washers off that are located at the end of the guide. This will void any warranty. I have asked for other solutions several more times and have not received a reply. Now I have been requesting a return authorization, and still with no reply.
This seems to be a great tool but is usless to me without a proper solution to fitting it to my table saw.
I have jst purchased a Delta mortising jig that works fine.
David E. Formby

Delta 34-184 Universal-Deluxe Tenoning Jig
The Delta 34-184 Universal-Deluxe Tenoning Jig didn't fit my Table saw. They shipped very qickly and was satisfied with the service. However the jig didn't fit.

Great tool!
This has been reviewed as the best Tenoning jig and this source was at least $20 below other market costs and was delivered quickly and in perfect shape!

Great tool, be prepared to tune it.
As most will attest, the tool comes set for a right tilt saw. This seems strange since most saws are now left tilt. This operation requires you to remove the guide and adjuster and relocate the guide to another set of pre-drilled holes. When I re-assembled the tool, I could not square it to the table. The holes were drilled out of allignment in the base! It is beyond me how that happens. If the tool is built using a CNC machine, it should be impossible. Delta must be using low skilled laborers to manually drill the holes, that's the only way it could happen. (What was the quality inspector doing when this mistake went by.) So, off to my drill press to open up the hole. What's up with the paint? Even after I got the packing grease off, the paint was not the same color. Even on the same part. Minor gripe, but it goes towards quality.

Operation: The design is excellent. Having two handles on the tool promotes safe operation. The clamp bar allows adjustment front to back so clamping pressure can be placed exactly where you want it. Use an accurate square when setting up your cuts just to be sure.

I believe this tool is the best in class, but the fit and finish could be better. I own several Delta tools - DJ-20 jointer, variable speed grinder, protable bench jointer, 12 1/2" portable planer. I hope Delta gets their act together and focuses on quality. They need to get back to their former glory.

Great tenons the fist time.
This machine works as advertised. It cuts clean concise tenons that are 100% repeatable. It is massive and just plows the material through the saw blade.
Set up took a while but that was me being overly careful. Great tool.
This is the better of the two you can get from Delta. My review of the other jig was meant to be for this one. The other is lower priced but not nearly as accurate as this one.
Sorry for the mix up!