Accessories

Delta Fence System
Very nice fence system! Brougth new life to my old contractors saw. Very well made and very easy to install. Highly recommend!

Delta 36-T30 Fence and Rail System
I own a 1950 Delta Unisaw which came with the Jet-Lock fence and rail system. I wanted to upgrade to a more precise fence and rail system but did not want to spend $300-$400 for a Beisemeyer. This is a great bang for the buck. It is extremely accurate and well manufactured. I would have given this product four stars if it weren't for this difficulty in mounting this to my Unisaw. I actually had to machine two special stepped spacers in order to mount the front rail to the table. I believe this is due to the "old" Unisaw table design where the holes in the front of the table are counterbored with a non-standard bolt hole and counter-bore size for use with the Jet-Lock 1-3/8" diameter rails. This may not be the case for the newer Unisaws.

It got the job done!
Having "rescued" a saw from being thrown away, this fixed the problem of no fence and gave a possible addition to the garbage dump a longer life. The fence is precise and well-made, and fit perfectly.

Nice Fence, Difficult to install on non Delta saw
I bought this fence after reading the reviews here at Amazon. The Delta website says it can be installed on other saws, I have a 20 year old Craftman saw that needed a fence update and I liked the price of this fence. The instructions for installation are very staight forward if your saw is the Delta saw that this fence is paired with. If you are installing it on any other saw, your on your own. None of the holes in my saw matched up with the holes in the fence rails. I had to drill and tap four of the holes because they lined up with cast bracing on the underside of the table, I only had 4 holes that did not have braces behind them. There is very little room for error when you drill your own holes because a 16th of an inch to high or to low and the fence will drag on the table or leave to big of a gap. Some of this gap can be corrected by moving to facing on the fence up or down, but I would recommend measuring very carefully before you drill. I wound up mocking up the whole system and clamping it to my saw to make sure I had the correct clearences before I did my final drilling and installation. I have about 3 hours in it so far. I will do the final adjustments on the fence angles tonight. Like I said, this looks like it's going to be a real nice fence, I just wish Delta would include better instructions for Non Delta installations. Plan on buying a 17/64" drill bit, a 5/16" drill bit, and a 8mm x 1.25 tap. If you wind up needing to drill into the rails (I did) you will need a counter sink as well, you might also buy 2 of the 5/16" bits, the rails are really hand on the bits. Take your time to get it right the first time and you should do fine, Good Luck.

Delta T-30
Fence works great. There is very little adjustments needed to the fence. Fence comes with side to sid tilt adjustments and Pendulum angle adjustments. Wood doesn't bind or kick back when ripping. This item was shipped and delivered on the date that was given.